Important: The iPrism Console menu on both the Model 1200 and Model 3000 are meant for troubleshooting and maintenance. NEVADA-1668 is a software build name-number.

Your prompt is the currently configured IP address of the iPrism. Your software version (v3.510) is shown above, followed by model number (m1200) and then appliance serial number (65541). Tip: Sometimes, Hyperterminal is finicky about making the initial connection, requiring that you power-off and power-on the iPrism, or that you disconnect/reconnect Hyperterminal, or that you run through the connection diaglogue again, as shown above.

Click OK, and hit Enter, and you should then see the iPrism console menu below. Name your connection (any name), specify the correct PC COM port, and set your baud rate to 9600, taking the defaults for the remaining COM port settings.Ĭlicking ' Restore Defaults' will give you the settings you need automatically. Start > Programs > Accessories > Communications > HyperTerminalįrom Run command type 'HYPERTRM' and EnterĪ banner will display for a few seconds before the application opens.

If you do not initially receive, or later misplace this cable, please contact EdgeWave for another cable. You cannot use a standard serial cable for the diagnostic connection. Note: Even though the console cable has DB9 connectors at each end, it is not a standard serial cable (different pin configuration). The console port is in back on the iPrism and is blue.

Use the Console Cable shipped with your appliance to connect the PC & iPrism. To access the iPrism menu system, you must do the following:Ĭable the grey Null-Modem cable to PC/Laptop and M-series iPrism: Starting Console for Advanced Troubleshooting

Hyperterminal software